SincpacC3D
General Information
Command Summary
The Ribbon Interface
|
SincpacC3D
General Information
Command Summary
The Ribbon Interface |
Description
The Sincpac-C3D now features a Ribbon interface. (This Ribbon interface is not available in the 2008 or 2009 versions.)
The Ribbon interface is automatically loaded into your active Toolspace. There is no need to do any special configuration to get the Ribbon interface, and the Sincpac-C3D tab will automatically appear in the Ribbon for each Workspace. Should you desire, you can remove the Sincpac-C3D tab from the Ribbon by using the SP command.
The Ribbon Interface looks like this:
The above image shows the two parts of the Ribbon. When SPRibbonTabCount is set to 2, the Ribbon is split into two parts, as shown above. This is ideal for smaller monitors. However, for larger monitors, it is more convenient to leave SPRibbonTabCount set to 1, so all Sincpac commands are on the same Ribbon tab.
You may hover the cursor over any button in the Ribbon to see an extended description of the command. While hovering over a Ribbon button, you may also hit F1 to open the complete Help for that command. Note that, if you do not have the Complete Edition of the Sincpac-C3D, you will still see unavailable commands in the Ribbon, but the buttons will be disabled (greyed out).
You may encounter situations where, for some reason, the Sincpac-C3D Ribbon disappears. Should this happen, reload your Workspace, and the Sincpac-C3D Ribbon tab should reappear. You may also use the SPRibbonEnabled command to refresh the Sincpac-C3D tab in the Ribbon.
See Also
Enables or disables the Sincpac-C3D tab in the Ribbon interface.
Specifies how many tabs to use in the Ribbon interface for the Sincpac-C3D. Splitting the commands into two Ribbon tabs improves ease-of-use on small monitors.
